TRODAT (Shandong) Marine Engineering Co., Ltd
+86-0536-2222696

Points to pay attention to when installing the seal ring of the dredger oil tank

Feb 12, 2020

Installing the seal ring can prevent oil leakage in the oil tank of the dredger, but we must pay attention to some problems when installing the seal ring.

1. Before installing the sealing ring, check whether the quality of the sealing ring is qualified, especially the position of the lip, and there should be no damage or defects. After inspecting the quality, check whether the size of the sealing ring meets the size of the cylinder.

2. When installing the position of the lip ring, such as the end of the cylinder and piston rod, it should be chamfered at 15 to 30 degrees, so as to avoid damage to the lip of the lip ring during installation. .

3. In the process of installing the lip ring, if the undercut or threaded surface is to be passed, the sleeve is placed at the position to be passed. Or in the design process, the diameter of the thread and the undercut groove is smaller than the inner diameter of the lip ring. If you want to pass through the threaded surface and orifice, be sure to use the inner diameter of the passing position larger than the outer diameter of the lip ring.

4. In order to reduce the resistance during assembly, apply lubricating oil to the lip ring and the mounting part during the installation process.

5. When installing, try to reduce the excessive stretch to avoid plastic deformation. If the temperature of the installation place is low, the lip ring can be heated in hot oil at about 60℃, but it should not exceed the temperature of the lip.

6. If the working pressure is greater than 20MPa, in addition to the compound lip ring, a retaining ring must be added to prevent the lip ring from being squeezed out. The retaining ring is installed on the side of the root of the lip ring. When the lip ring is installed in the cylinder, in order to prevent the oblique cut of the retaining ring from being cut, after putting it in the groove, use lubricating oil to tilt the The incision is glued and fixed and then installed.