TRODAT (Shandong) Marine Engineering Co., Ltd
+86-0536-2222696
Contact Us

Rubber Discharging Pipes Maintenance

Sep 27, 2021

Rubber Discharging pipes Maintenance:

(1) ultra-high pressure cleaner in working condition, the hose shall not be twisted, and try to avoid bending. If you need to bend, to ensure that the bending radius is not too small, generally not less than 15 times the outer diameter of the tube, otherwise it will lead to the reinforcement layer of the outer steel wire being stretched, the inner steel wire will be compressed, thus reducing the entire ultra-high pressure hose pressure strength, and ultimately affect the service life of the hose.

(2) ultra-high pressure cleaner in the working state, ultra-high pressure hose can not be crushed by heavy objects, sharp objects touching, not bending, to protect the outer layer do not wear too much; hanging the use of a high-pressure tube to short distance fixed firmly.

(3) In the operation of specific cleaning operations, try to avoid frequent opening and closing of the handheld high-pressure gun, in order to reduce the pressure pulse on the hose, thereby extending the service life of the hose.

(4) In order to prevent accidents and prevent injury when the joint falls off or is damaged, the ultra-high pressure hose should be connected with a protective sleeve of steel wire braid connecting the two ends.

(5) In the installation and disassembly of the ultra-high pressure hose connection, can not be forced to remove and screw, to protect the connection threads of the fillet, while requiring the installation of the outer surface of the threads need to be coated with the lubricating sticky oil, after disassembly use the protective sleeve to protect the connection threads.

(6) ultra-high pressure hose in the case of long periods of non-use, should be emptied of internal water, according to the prescribed size of the hose bent into a coil and placed flat. Special attention should be paid to the bending of the parts near the joint of the ultra-high pressure hose, the joint should be coated with anti-rust oil to avoid contact with high temperature, high pressure, and strong corrosive media.