I believe that many customers and friends have encountered this problem when operating the dredger (dredge), that is, when the dredger is working, the suction port is often blocked by rocks and other debris, causing the mud pump to fail to work properly.
1. Adopt a welded grille on the mud suction port to prevent large stones from entering the suction port and then into the impeller in the pump. When small stones are squeezed on the grille, it is necessary to clean up the debris in time.
2. Weld the grille between the arms of the reamer, wind the wire cable on the reamer, and weld the iron inside the reamer to prevent stones from entering the mud suction port.
3 Install a relatively easy-to-disassemble pig cage device after the suction pipe.
The dredger encounters many rocky conditions is also a difficult problem in the dredger industry. In short, everyone should consider the input of the dredger (dredging vessel) from various aspects to avoid causing the dredger's mud pump. Damage.
